SensorsModerate✅ DIY Friendly

P0108

MAP Sensor Circuit High Input

The ECM has detected that the Manifold Absolute Pressure (MAP) sensor signal voltage is higher than the expected operating range, causing the ECM to calculate an inaccurate engine load and richen the fuel mixture.

SeverityModerate
CategorySensors
Est. Repair Cost$30–$200
Code TypePowertrain
DIY RepairYes
DifficultyBeginner

⚡ Common Causes

  • ›Short to voltage in signal wire
  • ›Failed MAP sensor
  • ›Blocked vacuum line
  • ›ECM fault

⚠️ Symptoms

  • ›High idle
  • ›Lean running
  • ›Check engine light

✅ How to Fix — Step by Step

  • Step 1:Inspect vacuum line for blockage
  • Step 2:Check wiring
  • Step 3:Replace MAP sensor

🔧 Diagnostic Tools Required

Using the correct diagnostic tools helps identify the root cause of P0108 before replacing parts unnecessarily. Always confirm the fault using live data and manufacturer-recommended diagnostic procedures.

🚗 Vehicles Commonly Reporting P0108

Ford F-150Chevrolet SilveradoToyota CamryHonda AccordNissan AltimaHyundai Sonata

❌ Common Mistakes to Avoid

📋 Technical Service Bulletins

Vehicle-specific MAP sensor diagnostics and ECM calibration updates may vary by manufacturer. Check service information for applicable bulletins.

🏭 Manufacturer-Specific Notes

Ford P0108

Compare MAP sensor data with barometric pressure and inspect the signal circuit before condemning the sensor.

GM P0108

Check the MAP sensor reference, low-reference, and signal circuits before replacing the sensor.

🎓 Expert Tip: With the engine off and ignition on, the MAP reading should generally be close to atmospheric pressure. A reading that is far outside expected pressure can help distinguish a sensor or wiring problem from an engine vacuum problem.
💡 Pro Tip: Compare live MAP sensor voltage against a known-good barometric reading at key-on, engine-off; a value far outside 4-5V at sea level with the engine off points to a bad sensor rather than a wiring issue.

Repair Cost Estimate

Full Repair Estimate
$30–$200
DIY Possible?
YES
Severity
Moderate
Diagnosis Time
30–60 minutes
Repair Time
30–90 minutes

Frequently Asked Questions

What does OBD2 code P0108 mean?+
P0108 stands for MAP Sensor Circuit High Input. The ECM has detected that the Manifold Absolute Pressure (MAP) sensor signal voltage is higher than the expected operating range, causing the ECM to calculate an inaccurate engine load and richen the fuel mixture.
What causes code P0108?+
Short to voltage in signal wire; Failed MAP sensor; Blocked vacuum line; ECM fault
How do I fix code P0108?+
Inspect vacuum line for blockage; Check wiring; Replace MAP sensor
How much does it cost to fix P0108?+
Estimated repair cost for P0108 is $30–$200.
Is P0108 DIY-friendly?+
Yes — P0108 is generally DIY-friendly with basic tools.

References

Related Codes

P0107MAP Sensor Circuit Low Input
ModerateDIY
P0500Vehicle Speed Sensor Malfunction
ModerateDIY
P0501Vehicle Speed Sensor A Range/Performance
ModerateDIY
P0551Power Steering Pressure Sensor Circuit Range/Performance
ModerateDIY
P0552Power Steering Pressure Sensor Circuit Low
ModerateDIY
P0553Power Steering Pressure Sensor Circuit High
ModerateDIY