Throttle/Pedal Position Sensor A Circuit High Input
TPS circuit voltage is above expected range.
SeverityCritical
CategoryEngine
Est. Repair Cost$100–$400
Code TypePowertrain
DIY RepairYes
DifficultyIntermediate
⚡ Common Causes
›Open circuit in TPS signal wire
›Short to power
›Faulty TPS sensor
›Damaged wiring
⚠️ Symptoms
›Engine limp mode
›Check engine light
›Erratic throttle response
›Possible stalling
✅ How to Fix — Step by Step
Step 1:Check for short to power in signal wire
Step 2:Test TPS reference and ground
Step 3:Replace TPS
Step 4:Inspect wiring harness
🔧 Diagnostic Tools Required
✔OBD-II Diagnostic Scanner
✔Digital Multimeter
✔Fuel Pressure Gauge
✔Compression Tester
✔Spark Tester
Using the correct diagnostic tools helps identify the root cause of P0123 before replacing parts unnecessarily. Always confirm the fault using live data and manufacturer-recommended diagnostic procedures.
🚗 Vehicles Commonly Reporting P0123
Vehicles using electronic throttle control or electronically monitored pedal-position sensorsExact sensor arrangement varies by manufacturer and engine
❌ Common Mistakes to Avoid
✘Replacing the sensor before testing the signal wire
✘Ignoring a possible short to voltage
✘Failing to inspect connector terminals
✘Skipping required calibration after repair
✘Condemning the ECM without proving the sensor circuit is good
📋 Technical Service Bulletins
Check manufacturer service information for high-signal faults, wiring repairs, throttle-body updates, and software or relearn procedures.
🏭 Manufacturer-Specific Notes
General P0123
P0123 thresholds and circuit definitions vary by vehicle. Confirm the sensor designation and expected signal range with OEM documentation.
🎓 Expert Tip: Compare the reported position with the second redundant sensor track if available. A disagreement between tracks can help isolate a sensor or circuit problem.
💡 Pro Tip: High TPS voltage with no throttle input means the sensor sees full throttle — dangerous for engine management.
Repair Cost Estimate
Full Repair Estimate
$100–$400
DIY Possible?
YES
Severity
Critical
Diagnosis Time
30–60 minutes
Repair Time
1–3 hours depending on component and wiring access
Frequently Asked Questions
What does OBD2 code P0123 mean?+
P0123 stands for Throttle/Pedal Position Sensor A Circuit High Input. TPS circuit voltage is above expected range.
What causes code P0123?+
Open circuit in TPS signal wire; Short to power; Faulty TPS sensor; Damaged wiring
How do I fix code P0123?+
Check for short to power in signal wire; Test TPS reference and ground; Replace TPS; Inspect wiring harness
How much does it cost to fix P0123?+
Estimated repair cost for P0123 is $100–$400.
Is P0123 DIY-friendly?+
Yes — P0123 is generally DIY-friendly with basic tools.
References
Manufacturer engine-control service information
OEM electronic throttle-control wiring diagrams
Vehicle-specific throttle and pedal position diagnostic procedures