The ECM has detected a fault on the serial data communication link (typically the internal ECM communication bus) used to share data between internal ECM processors or with other modules.
SeverityCritical
CategoryNetwork / CAN
Est. Repair Cost$300–$1500
Code TypePowertrain
DIY RepairProfessional
DifficultyProfessional
⚡ Common Causes
›Failed ECM
›Wiring fault on CAN bus
›Damaged communication harness
›Corroded ground connection
⚠️ Symptoms
›Multiple system faults
›Modules not communicating
›Possible no-start
✅ How to Fix — Step by Step
Step 1:Check battery and grounds
Step 2:Inspect CAN bus wiring
Step 3:Test ECM power and ground
Step 4:Replace ECM if confirmed failed
🔧 Diagnostic Tools Required
✔OBD-II Diagnostic Scanner
✔CAN Bus Tester
✔Digital Multimeter
✔Oscilloscope
Using the correct diagnostic tools helps identify the root cause of P0600 before replacing parts unnecessarily. Always confirm the fault using live data and manufacturer-recommended diagnostic procedures.
🚗 Vehicles Commonly Reporting P0600
Modern vehicles using serial or CAN-based module communicationExact diagnostic procedure varies by manufacturer and network architecture
❌ Common Mistakes to Avoid
✘Replacing the PCM or another module before testing the communication network
✘Clearing all codes without recording their original order
✘Ignoring low battery voltage
✘Testing individual modules without checking the shared network wiring
📋 Technical Service Bulletins
Check manufacturer service information for known network communication faults, software updates, wiring repairs, and module-specific diagnostic procedures.
🏭 Manufacturer-Specific Notes
All manufacturers P0600
The exact serial communication architecture differs between vehicles. Use the manufacturer wiring diagram and diagnostic flowchart for the affected model.
🎓 Expert Tip: When several modules report communication errors at the same time, diagnose the shared power, ground, and network circuits before replacing individual modules.
💡 Pro Tip: This code often points to a marginal ECM ground or internal ECM fault — verify all ECM grounds are clean and tight before considering ECM replacement.
Repair Cost Estimate
Full Repair Estimate
$300–$1500
DIY Possible?
PRO
Severity
Critical
Diagnosis Time
1–3 hours
Repair Time
1–6+ hours depending on the network fault
Frequently Asked Questions
What does OBD2 code P0600 mean?+
P0600 stands for Serial Communication Link Circuit. The ECM has detected a fault on the serial data communication link (typically the internal ECM communication bus) used to share data between internal ECM processors or with other modules.
What causes code P0600?+
Failed ECM; Wiring fault on CAN bus; Damaged communication harness; Corroded ground connection
How do I fix code P0600?+
Check battery and grounds; Inspect CAN bus wiring; Test ECM power and ground; Replace ECM if confirmed failed
How much does it cost to fix P0600?+
Estimated repair cost for P0600 is $300–$1500.
Is P0600 DIY-friendly?+
P0600 typically requires professional equipment and a qualified mechanic.